01-21-2014, 03:29 PM
Tom,
Thanks for another great video. Could 1/2" Aluminum be used for the fixture plate? I don't have any steel big enough in my scrap box. I would guess the cutout for the torch would have to be a bit bigger to keep from melting the aluminum.
Chuck
Thanks for another great video. Could 1/2" Aluminum be used for the fixture plate? I don't have any steel big enough in my scrap box. I would guess the cutout for the torch would have to be a bit bigger to keep from melting the aluminum.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.