Half Nut Adjustments?
#6
(04-22-2012, 09:31 AM)Wongster Wrote: When the apron was put back and half nut engaged, turning the handwheel is still a pain.
Regards,
Wong
Wong, I think you're right it is a pain, once the half nuts are engaged you should not turn the hand wheel, you will break some thingCool
Smiley-eatdrink004
Dave
Reply
Thanks given by:


Messages In This Thread
Half Nut Adjustments? - by Wongster - 04-22-2012, 09:31 AM
RE: Half Nut Adjustments? - by Highpower - 04-22-2012, 10:07 AM
RE: Half Nut Adjustments? - by Wongster - 04-22-2012, 10:14 AM
RE: Half Nut Adjustments? - by Highpower - 04-22-2012, 10:26 AM
RE: Half Nut Adjustments? - by DaveH - 04-22-2012, 10:26 AM
RE: Half Nut Adjustments? - by Wongster - 04-22-2012, 05:18 PM
RE: Half Nut Adjustments? - by DaveH - 04-22-2012, 05:27 PM
RE: Half Nut Adjustments? - by stevec - 04-23-2012, 07:28 AM
RE: Half Nut Adjustments? - by DaveH - 04-22-2012, 10:50 AM
RE: Half Nut Adjustments? - by Wongster - 04-22-2012, 05:51 PM
RE: Half Nut Adjustments? - by DaveH - 04-22-2012, 06:02 PM
RE: Half Nut Adjustments? - by Wongster - 04-22-2012, 10:41 PM
RE: Half Nut Adjustments? - by stevec - 04-23-2012, 07:42 AM
RE: Half Nut Adjustments? - by Wongster - 04-23-2012, 07:52 AM
RE: Half Nut Adjustments? - by DaveH - 04-23-2012, 08:36 AM
RE: Half Nut Adjustments? - by Wongster - 04-23-2012, 09:53 AM
RE: Half Nut Adjustments? - by stevec - 04-23-2012, 11:28 AM
RE: Half Nut Adjustments? - by EdK - 04-23-2012, 11:35 AM
RE: Half Nut Adjustments? - by Wongster - 04-23-2012, 12:03 PM
RE: Half Nut Adjustments? - by EdK - 04-23-2012, 12:40 PM
RE: Half Nut Adjustments? - by Wongster - 04-23-2012, 06:29 PM
RE: Half Nut Adjustments? - by doubleboost - 04-23-2012, 03:16 PM
RE: Half Nut Adjustments? - by stevec - 04-23-2012, 03:19 PM
RE: Half Nut Adjustments? - by doubleboost - 04-23-2012, 03:27 PM
RE: Half Nut Adjustments? - by Wongster - 04-23-2012, 06:32 PM
RE: Half Nut Adjustments? - by DaveH - 05-10-2012, 08:13 AM
RE: Half Nut Adjustments? - by Wongster - 05-10-2012, 08:53 AM



Users browsing this thread: 3 Guest(s)