MetalworkingFun Forum › Machining › General Metalworking Discussion v
Raising equipment

Thread Modes
Raising equipment
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#4
01-20-2014, 10:53 AM
Why do they build lathes that low? My Summit with its wide apron kills my back after a while, have often thought of raising it, never thought of a steel riser though.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Raising equipment - by Mayhem - 01-20-2014, 05:13 AM
RE: Raising equipment - by awemawson - 01-20-2014, 06:20 AM
RE: Raising equipment - by stevec - 01-20-2014, 09:12 AM
RE: Raising equipment - by f350ca - 01-20-2014, 10:53 AM
RE: Raising equipment - by haroldmulder - 01-20-2014, 06:42 PM
RE: Raising equipment - by stevec - 01-21-2014, 08:31 AM
RE: Raising equipment - by Mayhem - 01-21-2014, 10:36 AM
RE: Raising equipment - by Mayhem - 01-23-2014, 06:59 AM
RE: Raising equipment - by PixMan - 01-23-2014, 08:54 PM
RE: Raising equipment - by Mayhem - 01-23-2014, 09:40 PM
RE: Raising equipment - by PixMan - 01-23-2014, 10:49 PM
RE: Raising equipment - by Mayhem - 01-24-2014, 07:31 AM
RE: Raising equipment - by Mayhem - 01-25-2014, 09:59 PM
RE: Raising equipment - by stevec - 01-26-2014, 07:55 AM



Users browsing this thread: 3 Guest(s)