|
Raising equipment
|
01-20-2014, 06:20 AM
Weld up some channel section with the open part of the channel 'outwards', made to the dimensions of the two bases. Drill holes to correspond with the hold down ones in the base, and repeat them on the floor side so you can fix her down if you need to. Bolt them to the lathe and you are good to go.
Andrew
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Thanks given by: Mayhem
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Raising equipment - by Mayhem - 01-20-2014, 05:13 AM
RE: Raising equipment - by awemawson - 01-20-2014, 06:20 AM
RE: Raising equipment - by stevec - 01-20-2014, 09:12 AM
RE: Raising equipment - by f350ca - 01-20-2014, 10:53 AM
RE: Raising equipment - by haroldmulder - 01-20-2014, 06:42 PM
RE: Raising equipment - by stevec - 01-21-2014, 08:31 AM
RE: Raising equipment - by Mayhem - 01-21-2014, 10:36 AM
RE: Raising equipment - by Mayhem - 01-23-2014, 06:59 AM
RE: Raising equipment - by PixMan - 01-23-2014, 08:54 PM
RE: Raising equipment - by Mayhem - 01-23-2014, 09:40 PM
RE: Raising equipment - by PixMan - 01-23-2014, 10:49 PM
RE: Raising equipment - by Mayhem - 01-24-2014, 07:31 AM
RE: Raising equipment - by Mayhem - 01-25-2014, 09:59 PM
RE: Raising equipment - by stevec - 01-26-2014, 07:55 AM
|
