MetalworkingFun Forum › Machinery › Lathes v
Quick Change Toolpost for Storebro

Thread Modes
Quick Change Toolpost for Storebro
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
The following 1 user Likes Hawkeye's post:
Mayhem (01-20-2014)
#31
01-20-2014, 12:04 AM
To my way of thinking, getting rid of the need for shims on the four-way or tweaking the rocker on the original toolpost makes almost anything else quick.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Quick Change Toolpost for Storebro - by Hawkeye - 12-31-2013, 12:46 AM
RE: Quick Change Toolpost for Storebro - by TomG - 01-07-2014, 12:12 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-01-2014, 05:42 AM
RE: Quick Change Toolpost for Storebro - by EdK - 01-03-2014, 12:33 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-19-2014, 03:23 AM
RE: Quick Change Toolpost for Storebro - by Hawkeye - 01-20-2014, 12:04 AM



Users browsing this thread: 3 Guest(s)