The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › How-To's v
Dovetail and Chamfer Measurement

Thread Modes
Dovetail and Chamfer Measurement
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
DaveH (01-20-2014)
#1
01-18-2014, 06:52 PM
There was a question on another forum about how to accurately measure a chamfer and since I've been meaning to add something similar to the my website, I decided that now was as good a time as any to crank one out.

The following chart can be used to accurately calculate the size and location of an angled surface, using a pin and a bit of trig. It will work for a dovetail, a chamfer, or any angled surface. I'll likely be shooting a video on how to use it tomorrow.

Tom

[Image: Chamfer%20Calculations_2.JPG]
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: EdK


Messages In This Thread
Dovetail and Chamfer Measurement - by TomG - 01-18-2014, 06:52 PM
RE: Dovetail and Chamfer Measurement - by Shawn - 01-20-2014, 03:28 PM
RE: Dovetail and Chamfer Measurement - by TomG - 01-20-2014, 04:11 PM
RE: Dovetail and Chamfer Measurement - by Shawn - 01-21-2014, 01:12 AM
RE: Dovetail and Chamfer Measurement - by Terry S - 01-21-2014, 10:38 AM
RE: Dovetail and Chamfer Measurement - by TomG - 01-21-2014, 12:17 PM
RE: Dovetail and Chamfer Measurement - by Terry S - 01-22-2014, 12:11 PM



Users browsing this thread: 1 Guest(s)