Parallels - what are the differences?
#3
The ultra thin ones are also good if you need to drill a hole that is close to the edge of the work piece. Soft-jaws would also be good in that situation.

Ed
Reply
Thanks given by:


Messages In This Thread
Parallels - what are the differences? - by Mayhem - 04-22-2012, 03:29 AM
RE: Parallels - what are the differences? - by EdK - 04-22-2012, 10:09 AM
RE: Parallels - what are the differences? - by Bogstandard - 04-22-2012, 12:36 PM



Users browsing this thread: 2 Guest(s)