MetalworkingFun Forum › Machining › General Metalworking Discussion v
Milling keyways in a long shaft?

Thread Modes
Milling keyways in a long shaft?
Gunney Offline
Freshman
**
Posts: 2
Threads: 0
Joined: Jan 2013
Location: Mobile, AL
The following 1 user Likes Gunney's post:
Highpower (01-17-2014)
#3
01-17-2014, 02:13 AM
I should add, though it should be obvious, that the vise can be used (assuming it is trammed well) between the v-blocks to easily align the shaft parallel to the table travel.
Gunney, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Milling keyways in a long shaft? - by cwoll - 01-17-2014, 01:18 AM
RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:11 AM
RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 10:32 AM
RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:13 AM
RE: Milling keyways in a long shaft? - by big job - 01-17-2014, 08:58 AM
RE: Milling keyways in a long shaft? - by PixMan - 01-17-2014, 01:19 PM
RE: Milling keyways in a long shaft? - by wrustle - 01-17-2014, 05:43 PM
RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 06:10 PM
RE: Milling keyways in a long shaft? - by TomG - 01-17-2014, 07:14 PM



Users browsing this thread: 2 Guest(s)