The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Milling keyways in a long shaft?

Thread Modes
Milling keyways in a long shaft?
cwoll Offline
Freshman
**
Posts: 3
Threads: 1
Joined: Jan 2014
Location: WA
#1
01-17-2014, 01:18 AM (This post was last modified: 01-17-2014, 01:20 AM by cwoll.)
I have a 8ft long 2inch shaft to machine some keyways in all along the shaft. The keyways need to be aligned. What is the best way to make sure the keyways stay aligned when moving the shaft in the vice?

Thanks
Clarence
cwoll, proud to be a member of MetalworkingFun Forum since Jan 2014.
Reply
Thanks given by:


Messages In This Thread
Milling keyways in a long shaft? - by cwoll - 01-17-2014, 01:18 AM
RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:11 AM
RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 10:32 AM
RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:13 AM
RE: Milling keyways in a long shaft? - by big job - 01-17-2014, 08:58 AM
RE: Milling keyways in a long shaft? - by PixMan - 01-17-2014, 01:19 PM
RE: Milling keyways in a long shaft? - by wrustle - 01-17-2014, 05:43 PM
RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 06:10 PM
RE: Milling keyways in a long shaft? - by TomG - 01-17-2014, 07:14 PM



Users browsing this thread: 1 Guest(s)