01-09-2014, 06:05 PM
Use a brand new end mill and run the rpm wide open. Other than keeping the chips clear, that's about all you need to know.
Tom
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)
|
machining wood :) help please
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
machining wood :) help please - by ieezitin - 01-09-2014, 02:46 PM
RE: machining wood :) help please - by dallen - 01-09-2014, 02:56 PM
RE: machining wood :) help please - by ieezitin - 01-09-2014, 06:01 PM
RE: machining wood :) help please - by TomG - 01-09-2014, 06:05 PM
RE: machining wood :) help please - by f350ca - 01-09-2014, 08:52 PM
RE: machining wood :) help please - by ieezitin - 01-14-2014, 07:01 PM
RE: machining wood :) help please - by Micktoon - 01-14-2014, 07:06 PM
RE: machining wood :) help please - by terrywerm - 01-14-2014, 11:29 PM
RE: machining wood :) help please - by EdK - 01-15-2014, 06:33 AM
RE: machining wood :) help please - by DaveH - 01-15-2014, 11:19 PM
RE: machining wood :) help please - by ieezitin - 01-18-2014, 10:08 AM
|
Users browsing this thread: 1 Guest(s)