|
KNURLING TOOL MY WAY
|
01-05-2014, 08:33 PM
(01-05-2014, 02:32 PM)dallen Wrote: are you using cut or upset rollers?? Dallen... Honestly i don't know the difference, i procured the knurling heads from a tool i had in the shop, it was a plunge side-wards type knurling tool. All the Best..... Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
KNURLING TOOL MY WAY - by ieezitin - 01-05-2014, 12:22 PM
RE: KNURLING TOOL MY WAY - by DaveH - 01-05-2014, 01:06 PM
RE: KNURLING TOOL MY WAY - by ieezitin - 01-05-2014, 01:15 PM
RE: KNURLING TOOL MY WAY - by TomG - 01-05-2014, 01:27 PM
RE: KNURLING TOOL MY WAY - by ieezitin - 01-05-2014, 01:42 PM
RE: KNURLING TOOL MY WAY - by dallen - 01-05-2014, 02:28 PM
RE: KNURLING TOOL MY WAY - by dallen - 01-05-2014, 02:32 PM
RE: KNURLING TOOL MY WAY - by ieezitin - 01-05-2014, 08:33 PM
RE: KNURLING TOOL MY WAY - by doubleboost - 01-05-2014, 05:04 PM
RE: KNURLING TOOL MY WAY - by krv3000 - 01-05-2014, 06:15 PM
RE: KNURLING TOOL MY WAY - by ieezitin - 01-05-2014, 08:28 PM
|
