01-05-2014, 04:38 AM
Well this bracket has been a bit more challenging to draw than I had imagined. Actually, it has been a challenge to measure it. I have been using the two machined faces on the back as my reference point. The bore running transversely through the bracket was the most difficult to establish the centre lines for and I'm not 100% that I have nailed it. The cast surfaces (as expected) are not reliable datum points.
I'd like some input on which hidden detail needs to be in which view. As I initially expected, it gets very messy if I put them all in. I've duplicated a couple of views in which I have excluded certain detail. In the top view, I've excluded the bore all together.
The side views are much easier to understand if the central bore and counterbore are shown only in one view and the screw holes in another. Is it acceptable to do it this way and do I need to indicate that a particular view is only showing partial detail?
Here is what I have so far. I've still got to add in the broken off parts and the aux view (still trying to figure that one out). Dimensions will be the final component.
I'd like some input on which hidden detail needs to be in which view. As I initially expected, it gets very messy if I put them all in. I've duplicated a couple of views in which I have excluded certain detail. In the top view, I've excluded the bore all together.
The side views are much easier to understand if the central bore and counterbore are shown only in one view and the screw holes in another. Is it acceptable to do it this way and do I need to indicate that a particular view is only showing partial detail?
Here is what I have so far. I've still got to add in the broken off parts and the aux view (still trying to figure that one out). Dimensions will be the final component.
Hunting American dentists since 2015.