01-03-2014, 08:59 PM
The other two jaws were supporting the work. Plenty of clamping force on the two 'working' jaws. The work would have to move a lot before the support jaws became loose. Plus, light cuts help with the safety factor. Only 0.5 mm per cut.
I couldn't move the work any deeper into the chuck without getting a chuck strike.
I couldn't move the work any deeper into the chuck without getting a chuck strike.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.