01-02-2014, 09:38 AM
I'm not very good but would take a stab at drawing it up, BUT would need the part in hand to do it with. I don't see it as that hard to draw, you have the basic information already in the part.
That one slot that is at and angle, I would slide the housing on a shaft and put it in some Vee Blocks on the Surface Plate then use a Protractor to find the angle.
That one slot that is at and angle, I would slide the housing on a shaft and put it in some Vee Blocks on the Surface Plate then use a Protractor to find the angle.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!