Whitworth Thread on a M24/47

Hello There, Guest! Register

Thread Modes

Whitworth Thread on a M24/47

aametalmaster Offline

Offline

MTLMSTR

Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio

#12

01-02-2014, 04:17 AM

Common sense tells me it should be a good fit with no slop screwing on like with any gun regardless of the brand...Bob

Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Whitworth Thread on a M24/47 - by tighten tournique - 12-26-2013, 10:50 PM

RE: Whitworth Thread on a M24/47 - by aametalmaster - 12-27-2013, 04:18 AM

RE: Whitworth Thread on a M24/47 - by awemawson - 12-27-2013, 05:04 AM

RE: Whitworth Thread on a M24/47 - by stevec - 12-27-2013, 07:22 AM

RE: Whitworth Thread on a M24/47 - by tighten tournique - 12-27-2013, 05:34 PM

RE: Whitworth Thread on a M24/47 - by tighten tournique - 12-27-2013, 05:45 PM

RE: Whitworth Thread on a M24/47 - by aametalmaster - 12-27-2013, 08:45 PM

RE: Whitworth Thread on a M24/47 - by Highpower - 12-29-2013, 09:16 AM

RE: Whitworth Thread on a M24/47 - by tighten tournique - 12-27-2013, 10:57 PM

RE: Whitworth Thread on a M24/47 - by aametalmaster - 12-28-2013, 05:56 AM

RE: Whitworth Thread on a M24/47 - by unioncreek - 01-09-2014, 03:52 PM

RE: Whitworth Thread on a M24/47 - by tighten tournique - 01-01-2014, 11:03 PM

RE: Whitworth Thread on a M24/47 - by aametalmaster - 01-02-2014, 04:17 AM

RE: Whitworth Thread on a M24/47 - by unioncreek - 01-09-2014, 03:54 PM

RE: Whitworth Thread on a M24/47 - by tighten tournique - 01-09-2014, 09:55 PM

Users browsing this thread: 4 Guest(s)