01-01-2014, 01:08 AM
(12-31-2013, 08:12 PM)dallen Wrote: I checked out some of the photos, be something to see it run doing what it was designed to do.
I take it that you will weld the handle up from different pieces, would make for an easy casting.
DA
Yes i will weld it up from smaller parts. I couldn't make it in one piece with what i have for machines...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...