12-30-2013, 08:25 PM
(12-30-2013, 08:00 PM)f350ca Wrote: Made up a bracket to mount a snow plough on a font end loader. This will bolt into the bucket and the plough arms pin into it. The supplied plate was 3/4 inch mystery metal, drilled the holes to 1 1/4 then used the boring head to take them to 1 1/2, was some tough cutting.
Laid the first pass with the mig then ran out of gas, I've become some rough using stick, no final weld photos.
Your welds look really nice, and I'm sure that even your stick welding job came out looking better than anything I could do.
That said, we have one member here who welds better than anyone I've ever seen! Just wait until you see welds done by "Allescence", a.k.a. Jennifer. She is so talented it's unreal.