12-30-2013, 06:45 PM
so with a full profile insert I would need to have one for each different thread pitch that I was going to cut,
I have several different holders, is a small 3/8 holder designed to use the 16ER series inserts, the one I use the most is a TLSR-163D Top Loc that I modified by cutting a dovetail in it so that it mounts directly onto the QCTP on my 12 inch lathe and the inserts I have are some that I got off of the Evil Bay for like cheap but I like it cause it does a decent job of threading, not sure on the insert number but I know that there are a couple different ones cause some are purple and some TIN coated.
I also have both a right and left vertical threading holders but don't care for them too much, something about them I can't put my finger on that I don't like.
I have several different holders, is a small 3/8 holder designed to use the 16ER series inserts, the one I use the most is a TLSR-163D Top Loc that I modified by cutting a dovetail in it so that it mounts directly onto the QCTP on my 12 inch lathe and the inserts I have are some that I got off of the Evil Bay for like cheap but I like it cause it does a decent job of threading, not sure on the insert number but I know that there are a couple different ones cause some are purple and some TIN coated.
I also have both a right and left vertical threading holders but don't care for them too much, something about them I can't put my finger on that I don't like.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!