|
Tangential Toolholder
|
12-27-2013, 11:43 AM
I suppose you could make it like a machinist's jack, with the underside of the bolt head trued up and a good jam nut to lock it. That would make the initial setup a bit easier.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tangential Toolholder - by Hawkeye - 12-25-2013, 12:42 AM
RE: Tangential Toolholder - by Arbalest - 12-25-2013, 05:58 AM
RE: Tangential Toolholder - by TomG - 12-25-2013, 02:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-25-2013, 11:53 PM
RE: Tangential Toolholder - by Arbalest - 12-26-2013, 02:28 AM
RE: Tangential Toolholder - by the artfull-codger - 12-26-2013, 05:28 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 04:45 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 06:15 AM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 06:37 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 01:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-27-2013, 11:43 AM
RE: Tangential Toolholder - by EdK - 12-27-2013, 12:18 PM
RE: Tangential Toolholder - by aRM - 05-09-2015, 11:40 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 03:57 PM
RE: Tangential Toolholder - by how'sitwork? - 05-06-2015, 04:57 PM
RE: Tangential Toolholder - by Arbalest - 05-10-2015, 04:28 AM
|
