12-27-2013, 04:18 AM
I have threaded quite a few Mausers/GEW's in the lathe and have only used a 55 degree ground tool bit. I have never used a 60 degree but i have seen and read about people who do. Myself i would rather do it right and make them match...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...