|
Wife's Christmas gift
|
12-24-2013, 11:04 AM
(12-24-2013, 01:52 AM)ScrapMetal Wrote: ... My worry with putting it back in the lathe to bevel the edge is that I won't get it "just right" and the bevel won't be consistent around the base.... Ron, Put it in the 4-jaw chuck and indicate off of the round portion. That should give you a consistent chamfer. Nice job, by the way.  Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Wife's Christmas gift - by ScrapMetal - 12-19-2013, 01:41 AM
RE: Wife's Christmas gift - by Shawn - 12-19-2013, 01:57 AM
RE: Wife's Christmas gift - by ScrapMetal - 12-19-2013, 02:31 PM
RE: Wife's Christmas gift - by TomG - 12-19-2013, 06:39 PM
RE: Wife's Christmas gift - by ScrapMetal - 12-19-2013, 08:08 PM
RE: Wife's Christmas gift - by ScrapMetal - 12-22-2013, 02:22 AM
RE: Wife's Christmas gift - by PixMan - 12-22-2013, 09:55 AM
RE: Wife's Christmas gift - by ScrapMetal - 12-22-2013, 05:56 PM
RE: Wife's Christmas gift - by Shawn - 12-22-2013, 07:44 PM
RE: Wife's Christmas gift - by Mayhem - 12-23-2013, 04:40 AM
RE: Wife's Christmas gift - by ScrapMetal - 12-23-2013, 09:55 PM
RE: Wife's Christmas gift - by PixMan - 12-23-2013, 11:36 PM
RE: Wife's Christmas gift - by ScrapMetal - 12-24-2013, 01:52 AM
RE: Wife's Christmas gift - by EdK - 12-24-2013, 11:04 AM
RE: Wife's Christmas gift - by Mayhem - 12-24-2013, 07:08 AM
RE: Wife's Christmas gift - by TomG - 12-24-2013, 09:01 AM
RE: Wife's Christmas gift - by DaveH - 12-24-2013, 01:40 PM
RE: Wife's Christmas gift - by ScrapMetal - 12-24-2013, 05:42 PM
RE: Wife's Christmas gift - by EdK - 12-24-2013, 06:51 PM
RE: Wife's Christmas gift - by Micktoon - 12-24-2013, 06:57 PM
RE: Wife's Christmas gift - by PixMan - 12-24-2013, 07:02 PM
RE: Wife's Christmas gift - by Mayhem - 12-24-2013, 07:33 PM
RE: Wife's Christmas gift - by ScrapMetal - 12-26-2013, 09:08 PM
RE: Wife's Christmas gift - by Mayhem - 12-26-2013, 11:57 PM
RE: Wife's Christmas gift - by TomG - 12-27-2013, 12:12 AM
RE: Wife's Christmas gift - by ScrapMetal - 12-27-2013, 02:51 AM
|
