12-22-2013, 09:00 AM
They both face the same way as that is the way the tool is used - facing you!
Only while zeroing the gauges to the magnet (that remains stuck at one spot on the table) is the tool swung to get gauge #2 over the same position that gauge #1 was zereod. From then on you bring both gauges onto the table, and adjust the head tramming until they read the same.
Andrew
Only while zeroing the gauges to the magnet (that remains stuck at one spot on the table) is the tool swung to get gauge #2 over the same position that gauge #1 was zereod. From then on you bring both gauges onto the table, and adjust the head tramming until they read the same.
Andrew
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.