Anyone here capable of gear cutting?

Hello There, Guest! Register

Thread Modes

Anyone here capable of gear cutting?

Mayhem Offline

Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#15

12-21-2013, 09:38 AM

(12-21-2013, 08:10 AM)PixMan Wrote: ...I just don't know if the Phase II rotary table has the accuracy to make a decent gear.

Only one way to find out Ken Big Grin

Big Grin

Hunting American dentists since 2015.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Anyone here capable of gear cutting? - by PixMan - 12-19-2013, 12:27 AM

RE: Anyone here capable of gear cutting? - by EdK - 12-19-2013, 07:34 AM

RE: Anyone here capable of gear cutting? - by Sunset Machine - 12-19-2013, 08:41 AM

RE: Anyone here capable of gear cutting? - by dallen - 12-19-2013, 08:49 AM

RE: Anyone here capable of gear cutting? - by PixMan - 12-19-2013, 09:17 AM

RE: Anyone here capable of gear cutting? - by EdK - 12-19-2013, 01:20 PM

RE: Anyone here capable of gear cutting? - by dallen - 12-19-2013, 01:55 PM

RE: Anyone here capable of gear cutting? - by PixMan - 12-19-2013, 03:20 PM

RE: Anyone here capable of gear cutting? - by tekfab - 12-19-2013, 06:20 PM

RE: Anyone here capable of gear cutting? - by PixMan - 12-20-2013, 12:06 AM

RE: Anyone here capable of gear cutting? - by awemawson - 12-20-2013, 03:58 AM

RE: Anyone here capable of gear cutting? - by Sunset Machine - 12-20-2013, 09:19 AM

RE: Anyone here capable of gear cutting? - by stevec - 12-20-2013, 02:57 PM

RE: Anyone here capable of gear cutting? - by PixMan - 12-21-2013, 08:10 AM

RE: Anyone here capable of gear cutting? - by Mayhem - 12-21-2013, 09:38 AM

RE: Anyone here capable of gear cutting? - by PixMan - 12-21-2013, 12:34 PM

RE: Anyone here capable of gear cutting? - by tekfab - 12-23-2013, 05:44 AM

RE: Anyone here capable of gear cutting? - by PixMan - 12-23-2013, 08:44 AM

Users browsing this thread: 5 Guest(s)