12-21-2013, 08:10 AM
I do think this may be the 14.5º pressure angle teeth.
I went to the Musumi site but they didn't seem to have anything in steel the right size. I think I'll be OK with getting someone on the "other machinist" website to help out. I make the blanks, I get some one to cut them.
Perhaps I could probably try doing it on my rotary table if I set it on the vertical, but a chuck for it and get a smaller gear tooth cutter. I just don't know if the Phase II rotary table has the accuracy to make a decent gear.
I went to the Musumi site but they didn't seem to have anything in steel the right size. I think I'll be OK with getting someone on the "other machinist" website to help out. I make the blanks, I get some one to cut them.
Perhaps I could probably try doing it on my rotary table if I set it on the vertical, but a chuck for it and get a smaller gear tooth cutter. I just don't know if the Phase II rotary table has the accuracy to make a decent gear.