Ron, I'm just curious as to how you lift the indicator off of the magnet,
you wrote "I would set the face then lift the indicator off of the magnet, set it back down on the magnet, and the indicator would no longer read zero."
was it by pulling up the top of the indicator spindle between your fingers? or by raising the spindle of the mill?
Another curiosity, if one is supposed to rotate the device 180° to read the amount of "tram" why isn't one indicator face 180° to the other.
you wrote "I would set the face then lift the indicator off of the magnet, set it back down on the magnet, and the indicator would no longer read zero."
was it by pulling up the top of the indicator spindle between your fingers? or by raising the spindle of the mill?
Another curiosity, if one is supposed to rotate the device 180° to read the amount of "tram" why isn't one indicator face 180° to the other.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.