MetalworkingFun Forum › Machinery › Lathes v
Centre Gauge

Thread Modes
Centre Gauge
Arbalest Offline
Sophmore
***
Posts: 175
Threads: 4
Joined: Sep 2012
Location: Dorset, UK
The following 1 user Likes Arbalest's post:
f350ca (12-18-2013)
#9
12-18-2013, 09:18 AM
Thanks very much for the comments guys. It's just sandblasted with Aluminium Oxide. I then give it a quick coat of Renwax or Lanolin to stop it rusting.
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
Centre Gauge - by Hawkeye - 12-17-2013, 12:29 AM
RE: Centre Gauge - by Arbalest - 12-17-2013, 05:04 PM
RE: Centre Gauge - by ieezitin - 12-17-2013, 05:49 PM
RE: Centre Gauge - by Hawkeye - 12-17-2013, 08:36 PM
RE: Centre Gauge - by Arbalest - 12-18-2013, 04:49 AM
RE: Centre Gauge - by awemawson - 12-18-2013, 06:40 AM
RE: Centre Gauge - by stevec - 12-18-2013, 07:28 AM
RE: Centre Gauge - by Mayhem - 12-18-2013, 07:49 AM
RE: Centre Gauge - by DaveH - 12-18-2013, 09:20 AM
RE: Centre Gauge - by Arbalest - 12-18-2013, 09:18 AM
RE: Centre Gauge - by Hawkeye - 12-18-2013, 11:10 PM



Users browsing this thread: 1 Guest(s)