MetalworkingFun Forum › Machining › Gunsmithing v
1905 Marlin '94 needs help.

Thread Modes
1905 Marlin '94 needs help.
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
The following 1 user Likes aametalmaster's post:
EdK (12-16-2013)
#6
12-16-2013, 02:52 PM
Well today i mated my breech bolt and the lever back to the receiver, prob a first time in 50 years and i see the lever is bent. Oh well time to straighten it then a good polish...Bob


Attached Files Thumbnail(s)
   
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
1905 Marlin '94 needs help. - by aametalmaster - 12-15-2013, 10:09 AM
RE: 1905 Marlin '94 needs help. - by TomG - 12-15-2013, 11:04 AM
RE: 1905 Marlin '94 needs help. - by DaveH - 12-15-2013, 06:54 PM
RE: 1905 Marlin '94 needs help. - by aametalmaster - 12-16-2013, 02:52 PM
RE: 1905 Marlin '94 needs help. - by 12345678910 - 12-17-2013, 01:06 AM
RE: 1905 Marlin '94 needs help. - by ETC57 - 12-19-2013, 06:34 PM
RE: 1905 Marlin '94 needs help. - by Highpower - 12-22-2013, 07:37 AM
RE: 1905 Marlin '94 needs help. - by TomG - 12-22-2013, 08:08 PM
RE: 1905 Marlin '94 needs help. - by racer-john - 12-22-2013, 08:44 PM
RE: 1905 Marlin '94 needs help. - by racer-john - 12-22-2013, 08:45 PM
RE: 1905 Marlin '94 needs help. - by racer-john - 12-22-2013, 08:52 PM
RE: 1905 Marlin '94 needs help. - by Highpower - 12-22-2013, 09:55 PM
RE: 1905 Marlin '94 needs help. - by DaveH - 12-24-2013, 01:49 PM



Users browsing this thread: 2 Guest(s)