MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Carriage Stop

Thread Modes
Carriage Stop
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#8
12-15-2013, 02:23 PM
Andrew,

My Hardinge has an auto stop on the leadscrew. It will repeatedly stop with in couple of thousandths, which is great for threading to a shoulder. The feed has a friction clutch which will slip if it hits a hard stop.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Carriage Stop - by Hawkeye - 12-15-2013, 12:25 AM
RE: Carriage Stop - by Mayhem - 12-15-2013, 06:31 AM
RE: Carriage Stop - by EdK - 12-15-2013, 09:47 AM
RE: Carriage Stop - by stevec - 12-15-2013, 06:51 AM
RE: Carriage Stop - by TomG - 12-15-2013, 11:08 AM
RE: Carriage Stop - by EdK - 12-15-2013, 12:42 PM
RE: Carriage Stop - by awemawson - 12-15-2013, 01:53 PM
RE: Carriage Stop - by TomG - 12-15-2013, 02:23 PM
RE: Carriage Stop - by Hawkeye - 12-16-2013, 01:04 AM
RE: Carriage Stop - by stevec - 12-16-2013, 06:59 AM
RE: Carriage Stop - by Hawkeye - 12-16-2013, 11:52 PM



Users browsing this thread: 1 Guest(s)