12-13-2013, 07:24 PM
Well I got the collet chuck finished this afternoon, cutting the taper was a relatively simple task, dialling in the compound was a slightly different story 
that took me awhile. I finally had to estimate the amount the compound would move as I tightened the two locking screws.
![[Image: 40ic.jpg]](http://img811.imageshack.us/img811/8954/40ic.jpg)
![[Image: brj2.jpg]](http://img5.imageshack.us/img5/8338/brj2.jpg)
I'm not exactly sure what would be considered acceptable runout? Until I get an accurate test bar of some sort I just made do with and edge finder.
Shawn
that took me awhile. I finally had to estimate the amount the compound would move as I tightened the two locking screws. I'm not exactly sure what would be considered acceptable runout? Until I get an accurate test bar of some sort I just made do with and edge finder.
Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.