Plasma Cutter
#6
Hey Jack, John would say the same about you, LOL. My wife had an uncle that was a Yorkshireman. He used to tell me to speak slowly and clearly so he could understand me! I'm also from upstate NY... Now living in E. Tennessee, where the locals say "Ya'll ain't from 'round here, are ya, huh?"

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Plasma Cutter - by doubleboost - 12-01-2013, 05:36 PM
RE: Plasma Cutter - by the penguin - 12-05-2013, 07:25 PM
RE: Plasma Cutter - by Mayhem - 12-05-2013, 09:04 PM
RE: Plasma Cutter - by EdK - 12-06-2013, 07:33 AM
RE: Plasma Cutter - by doubleboost - 12-13-2013, 01:02 PM
RE: Plasma Cutter - by chucketn - 12-13-2013, 01:59 PM
RE: Plasma Cutter - by EdK - 12-13-2013, 05:28 PM
RE: Plasma Cutter - by f350ca - 12-13-2013, 08:47 PM



Users browsing this thread: 2 Guest(s)