12-12-2013, 04:12 PM
That looks a mighty powerful system Shawn. I cant stop this wiper motor by hanging on to the saddle hand wheel. so yours must be great.
I wonder if it is possible to broach keyways or splines by indexing the chuck ???.
After getting the meter from the boat, I tested the draw it's 5A similar to
the motor's used on the mill table. so I will order a PWM control unit ans tap into the mill power supply.
I cant use the other end of the lead screw because I have a wheel to fine feed the saddle if I require it. one div = .001".
Brian.
I wonder if it is possible to broach keyways or splines by indexing the chuck ???.
After getting the meter from the boat, I tested the draw it's 5A similar to
the motor's used on the mill table. so I will order a PWM control unit ans tap into the mill power supply.
I cant use the other end of the lead screw because I have a wheel to fine feed the saddle if I require it. one div = .001".
Brian.
