It would probably work fine but I would probably change it to a ER25 anyway. Then make another one for ER32.
It's good practice and the material cost shouldn't be too much. I really like having mine and use it a lot.
If you haven't watched Doubleboosts you tube video series on making the ER32 holder you should. Very informative.
Best take away I got from it was to make sure the collet was expanded a bit and that your dial indicator is dead on
at lathe center height when you're dialing in the bore angle for the collet holder.
It's good practice and the material cost shouldn't be too much. I really like having mine and use it a lot.
If you haven't watched Doubleboosts you tube video series on making the ER32 holder you should. Very informative.
Best take away I got from it was to make sure the collet was expanded a bit and that your dial indicator is dead on
at lathe center height when you're dialing in the bore angle for the collet holder.
If it's crazy but it works, it's not crazy.