|
Power lead screw for 7x12.
|
12-07-2013, 03:37 PM
(12-07-2013, 03:12 PM)Brian Wrote: Before going any further I need a gear that will mesh with the change gears, so I am making a cutter (N01 module) so I can make the gear. Brian, is that cutter for a fly cutter? Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Power lead screw for 7x12. - by Brian - 12-07-2013, 03:12 PM
RE: Power lead screw for 7x12. - by chucketn - 12-07-2013, 03:37 PM
RE: Power lead screw for 7x12. - by Brian - 12-07-2013, 04:58 PM
RE: Power lead screw for 7x12. - by Brian - 12-08-2013, 08:35 AM
RE: Power lead screw for 7x12. - by Brian - 12-10-2013, 11:26 AM
RE: Power lead screw for 7x12. - by chucketn - 12-10-2013, 11:31 AM
RE: Power lead screw for 7x12. - by Shawn - 12-10-2013, 04:35 PM
RE: Power lead screw for 7x12. - by stevec - 12-10-2013, 05:23 PM
RE: Power lead screw for 7x12. - by Shawn - 12-11-2013, 09:33 PM
RE: Power lead screw for 7x12. - by Brian - 12-12-2013, 04:12 PM
|
