MetalworkingFun Forum › Machining › Projects v
Tractor repair

Thread Modes
Tractor repair
awemawson Offline
Junior
****
Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK
#4
12-07-2013, 07:25 AM
I bet that was great fun turning that down with the other arm sticking out - must have used ultra low speed I'm sure. One occasion when a tool post grinder would be justified.

Andrew
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
Tractor repair - by f350ca - 12-06-2013, 06:51 PM
RE: Tractor repair - by stevec - 12-06-2013, 09:45 PM
RE: Tractor repair - by f350ca - 12-07-2013, 12:41 AM
RE: Tractor repair - by awemawson - 12-07-2013, 07:25 AM
RE: Tractor repair - by f350ca - 12-07-2013, 09:45 AM
RE: Tractor repair - by f350ca - 12-07-2013, 08:08 PM
RE: Tractor repair - by TomG - 12-11-2013, 09:54 PM
RE: Tractor repair - by Mayhem - 12-07-2013, 09:13 PM
RE: Tractor repair - by PixMan - 12-07-2013, 10:38 PM
RE: Tractor repair - by f350ca - 12-07-2013, 11:56 PM
RE: Tractor repair - by Shawn - 12-09-2013, 09:03 PM
RE: Tractor repair - by DaveH - 12-10-2013, 05:41 AM
RE: Tractor repair - by f350ca - 12-11-2013, 09:16 PM
RE: Tractor repair - by f350ca - 12-12-2013, 10:47 AM
RE: Tractor repair - by f350ca - 12-12-2013, 01:17 PM



Users browsing this thread: 2 Guest(s)