MetalworkingFun Forum › Machining › Gunsmithing v
Machining an AR15 lower receiver

Thread Modes
Machining an AR15 lower receiver
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#52
12-01-2013, 07:28 AM
(06-20-2012, 04:48 PM)doubleboost Wrote: If we start playing with guns we will get locked up.
John
Same here in Canukistan, John.Smiley-nono
Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Machining an AR15 lower receiver - by Highpower - 06-20-2012, 04:35 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:47 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 05:03 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:55 PM
RE: Machining an AR15 lower receiver - by stevec - 12-01-2013, 07:28 AM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:10 PM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:41 PM
RE: Machining an AR15 lower receiver - by ETC57 - 06-20-2012, 06:12 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-21-2012, 09:12 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 01:49 PM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 04:33 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-21-2012, 03:26 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-22-2012, 10:51 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 10:17 PM
RE: Machining an AR15 lower receiver - by Mayhem - 06-21-2012, 10:30 PM
RE: Machining an AR15 lower receiver - by TomG - 06-22-2012, 06:28 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-22-2012, 09:25 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-29-2012, 08:38 PM
RE: Machining an AR15 lower receiver - by TomG - 06-29-2012, 08:46 PM
RE: Machining an AR15 lower receiver - by d65 - 11-30-2013, 09:49 PM



Users browsing this thread: 5 Guest(s)