11-27-2013, 06:27 AM
Yes Tom I've seen your video and used that technique on my manual mill.
But what I'm saying is what is your residual error - it isn't zero, there must be a finite error. I expect that you are using a 'tenths' indicator there but I don't think you say (unless I missed it) - so assuming you are at the 'tenths' level we are talking 2.5 microns or roughly where I am.
Andrew
But what I'm saying is what is your residual error - it isn't zero, there must be a finite error. I expect that you are using a 'tenths' indicator there but I don't think you say (unless I missed it) - so assuming you are at the 'tenths' level we are talking 2.5 microns or roughly where I am.
Andrew
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.