MetalworkingFun Forum › Machinery › Lathes v
Lathe advice

Thread Modes
Lathe advice
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#14
11-24-2013, 07:30 PM
Ah, Shawn. This addiction sure is compelling, isn't it? There are a few machines I'd have a hard time saying "no" to, even with no more space. Bigger lathe, surface grinder ...

If I wasn't in a strata, something like this would be worth considering for a new shop:

http://www.wimp.com/concretetents/
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Lathe advice - by Shawn - 11-21-2013, 02:00 AM
RE: Lathe advice - by awemawson - 11-21-2013, 04:29 AM
RE: Lathe advice - by tekfab - 11-21-2013, 03:30 PM
RE: Lathe advice - by TomG - 11-21-2013, 09:40 PM
RE: Lathe advice - by Hawkeye - 11-23-2013, 06:15 PM
RE: Lathe advice - by TomG - 11-23-2013, 07:40 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 01:02 AM
RE: Lathe advice - by awemawson - 11-24-2013, 03:50 AM
RE: Lathe advice - by Shawn - 11-24-2013, 03:56 AM
RE: Lathe advice - by stevec - 11-24-2013, 08:19 AM
RE: Lathe advice - by wrustle - 11-24-2013, 09:19 AM
RE: Lathe advice - by Sunset Machine - 11-24-2013, 11:06 AM
RE: Lathe advice - by Shawn - 11-24-2013, 12:41 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 07:30 PM
RE: Lathe advice - by Shawn - 11-24-2013, 07:39 PM



Users browsing this thread: 3 Guest(s)