|
Lathe advice
|
Good ole machines, had one years ago. If you think about it logically production runs are just multiple "one offs" its just easier to do multiples on a capstan lathe thats all and if your scoring a load of tooling then you shouldnt be stuck !
Mike
tekfab, proud to be a member of MetalworkingFun Forum since Apr 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe advice - by Shawn - 11-21-2013, 02:00 AM
RE: Lathe advice - by awemawson - 11-21-2013, 04:29 AM
RE: Lathe advice - by tekfab - 11-21-2013, 03:30 PM
RE: Lathe advice - by TomG - 11-21-2013, 09:40 PM
RE: Lathe advice - by Hawkeye - 11-23-2013, 06:15 PM
RE: Lathe advice - by TomG - 11-23-2013, 07:40 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 01:02 AM
RE: Lathe advice - by awemawson - 11-24-2013, 03:50 AM
RE: Lathe advice - by Shawn - 11-24-2013, 03:56 AM
RE: Lathe advice - by stevec - 11-24-2013, 08:19 AM
RE: Lathe advice - by wrustle - 11-24-2013, 09:19 AM
RE: Lathe advice - by Sunset Machine - 11-24-2013, 11:06 AM
RE: Lathe advice - by Shawn - 11-24-2013, 12:41 PM
RE: Lathe advice - by Hawkeye - 11-24-2013, 07:30 PM
RE: Lathe advice - by Shawn - 11-24-2013, 07:39 PM
|
