11-20-2013, 11:59 PM
Ok it's not really a project but I just cut about half the length of the bristles off the small painters brush (about 1-1.5" wide) I use for brushing off chips from the lathe mill etc and was amazed at how much better it works? No more chips caught up in the brush and it does a way better job of cleaning the ways and t-slots (pun intended). I have 5-6 of these brushes in the shop and they all got a quick haircut after trying the first one.
Shawn
Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.