MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe Safety

Thread Modes
Lathe Safety
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#8
11-14-2013, 07:01 PM
He did bump it with his face and it looked like it may have taken a few teeth, but it could have been a lot worse. I don't know what the deal was with that chuck, unless it needed to be opened farther because of the angle of the shaft.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Lathe Safety - by TomG - 11-14-2013, 03:44 PM
RE: Lathe Safety - by awemawson - 11-14-2013, 04:05 PM
RE: Lathe Safety - by DaveH - 11-14-2013, 04:39 PM
RE: Lathe Safety - by EdK - 11-14-2013, 04:43 PM
RE: Lathe Safety - by stevec - 11-14-2013, 04:52 PM
RE: Lathe Safety - by TomG - 11-14-2013, 05:36 PM
RE: Lathe Safety - by sasquatch - 11-14-2013, 06:27 PM
RE: Lathe Safety - by TomG - 11-14-2013, 07:01 PM
RE: Lathe Safety - by stevec - 11-14-2013, 07:35 PM
RE: Lathe Safety - by f350ca - 11-14-2013, 07:13 PM
RE: Lathe Safety - by ScrapMetal - 11-14-2013, 07:27 PM
RE: Lathe Safety - by eightball - 12-11-2013, 07:13 PM
RE: Lathe Safety - by TomG - 12-11-2013, 07:54 PM
RE: Lathe Safety - by eightball - 12-12-2013, 09:42 AM
RE: Lathe Safety - by stevec - 12-12-2013, 10:59 AM
RE: Lathe Safety - by Mayhem - 12-12-2013, 07:52 PM
RE: Lathe Safety - by TomG - 12-12-2013, 08:36 PM



Users browsing this thread: 6 Guest(s)