MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe Safety

Thread Modes
Lathe Safety
sasquatch Offline
Senior
*****
Posts: 825
Threads: 25
Joined: Jul 2012
Location: N. Bay Ontario
#7
11-14-2013, 06:27 PM
Good post Tom, and yes, i have watched that spinning chuck, thinking, "stay away!"

Wondering how many turns it took with the chuck wrench to loosen that rod, looked pretty odd to me, lots of turns.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Lathe Safety - by TomG - 11-14-2013, 03:44 PM
RE: Lathe Safety - by awemawson - 11-14-2013, 04:05 PM
RE: Lathe Safety - by DaveH - 11-14-2013, 04:39 PM
RE: Lathe Safety - by EdK - 11-14-2013, 04:43 PM
RE: Lathe Safety - by stevec - 11-14-2013, 04:52 PM
RE: Lathe Safety - by TomG - 11-14-2013, 05:36 PM
RE: Lathe Safety - by sasquatch - 11-14-2013, 06:27 PM
RE: Lathe Safety - by TomG - 11-14-2013, 07:01 PM
RE: Lathe Safety - by stevec - 11-14-2013, 07:35 PM
RE: Lathe Safety - by f350ca - 11-14-2013, 07:13 PM
RE: Lathe Safety - by ScrapMetal - 11-14-2013, 07:27 PM
RE: Lathe Safety - by eightball - 12-11-2013, 07:13 PM
RE: Lathe Safety - by TomG - 12-11-2013, 07:54 PM
RE: Lathe Safety - by eightball - 12-12-2013, 09:42 AM
RE: Lathe Safety - by stevec - 12-12-2013, 10:59 AM
RE: Lathe Safety - by Mayhem - 12-12-2013, 07:52 PM
RE: Lathe Safety - by TomG - 12-12-2013, 08:36 PM



Users browsing this thread: 5 Guest(s)