MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe Safety

Thread Modes
Lathe Safety
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#5
11-14-2013, 04:52 PM
Insurance? I somehow doubt. Pretty scary just the same, amazing how long it took to shut the lathe down and then how long it took to loosen the chuck jaws?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Lathe Safety - by TomG - 11-14-2013, 03:44 PM
RE: Lathe Safety - by awemawson - 11-14-2013, 04:05 PM
RE: Lathe Safety - by DaveH - 11-14-2013, 04:39 PM
RE: Lathe Safety - by EdK - 11-14-2013, 04:43 PM
RE: Lathe Safety - by stevec - 11-14-2013, 04:52 PM
RE: Lathe Safety - by TomG - 11-14-2013, 05:36 PM
RE: Lathe Safety - by sasquatch - 11-14-2013, 06:27 PM
RE: Lathe Safety - by TomG - 11-14-2013, 07:01 PM
RE: Lathe Safety - by stevec - 11-14-2013, 07:35 PM
RE: Lathe Safety - by f350ca - 11-14-2013, 07:13 PM
RE: Lathe Safety - by ScrapMetal - 11-14-2013, 07:27 PM
RE: Lathe Safety - by eightball - 12-11-2013, 07:13 PM
RE: Lathe Safety - by TomG - 12-11-2013, 07:54 PM
RE: Lathe Safety - by eightball - 12-12-2013, 09:42 AM
RE: Lathe Safety - by stevec - 12-12-2013, 10:59 AM
RE: Lathe Safety - by Mayhem - 12-12-2013, 07:52 PM
RE: Lathe Safety - by TomG - 12-12-2013, 08:36 PM



Users browsing this thread: 5 Guest(s)