|
Light Shades
|
11-13-2013, 04:09 AM
Get two very powerful rare earth magnets of the type with a counter sunk hole in them (cheap as chips on ebay) Stick them together either side of the bowl with a nut & bolt in the outer one for suspension. Adjust until it hangs as you want, then draw round them. Simples !!!
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Light Shades - by f350ca - 11-12-2013, 09:58 PM
RE: Light Shades - by TomG - 11-12-2013, 10:22 PM
RE: Light Shades - by f350ca - 11-12-2013, 11:58 PM
RE: Light Shades - by TomG - 11-13-2013, 12:20 AM
RE: Light Shades - by DaveH - 11-13-2013, 04:09 AM
RE: Light Shades - by EdK - 11-13-2013, 06:59 AM
RE: Light Shades - by awemawson - 11-13-2013, 04:09 AM
RE: Light Shades - by f350ca - 11-13-2013, 12:03 PM
RE: Light Shades - by awemawson - 11-13-2013, 12:20 PM
RE: Light Shades - by stevec - 11-13-2013, 07:30 PM
RE: Light Shades - by f350ca - 11-13-2013, 07:29 PM
RE: Light Shades - by TomG - 11-13-2013, 07:37 PM
RE: Light Shades - by stevec - 11-13-2013, 08:04 PM
RE: Light Shades - by f350ca - 11-13-2013, 08:22 PM
RE: Light Shades - by TomG - 11-13-2013, 09:09 PM
RE: Light Shades - by f350ca - 11-13-2013, 09:32 PM
RE: Light Shades - by awemawson - 11-14-2013, 05:23 AM
RE: Light Shades - by DaveH - 11-14-2013, 06:50 AM
RE: Light Shades - by stevec - 11-14-2013, 08:10 AM
RE: Light Shades - by DaveH - 11-14-2013, 02:17 PM
|
