MetalworkingFun Forum › Machining › General Metalworking Discussion v
Light Shades

Thread Modes
Light Shades
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#5
11-13-2013, 04:09 AM
Greg,
One way (cheap,cheerful and ruff); if the flat bottom is (say) 6" in diameter I just draw a 6" dia circle with a pair of compass on plain paper cut it out and place it on the flat bottom aligning it up the best I can, then centre punch the centre.
A bit rough and ready Big Grin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Light Shades - by f350ca - 11-12-2013, 09:58 PM
RE: Light Shades - by TomG - 11-12-2013, 10:22 PM
RE: Light Shades - by f350ca - 11-12-2013, 11:58 PM
RE: Light Shades - by TomG - 11-13-2013, 12:20 AM
RE: Light Shades - by DaveH - 11-13-2013, 04:09 AM
RE: Light Shades - by EdK - 11-13-2013, 06:59 AM
RE: Light Shades - by awemawson - 11-13-2013, 04:09 AM
RE: Light Shades - by f350ca - 11-13-2013, 12:03 PM
RE: Light Shades - by awemawson - 11-13-2013, 12:20 PM
RE: Light Shades - by stevec - 11-13-2013, 07:30 PM
RE: Light Shades - by f350ca - 11-13-2013, 07:29 PM
RE: Light Shades - by TomG - 11-13-2013, 07:37 PM
RE: Light Shades - by stevec - 11-13-2013, 08:04 PM
RE: Light Shades - by f350ca - 11-13-2013, 08:22 PM
RE: Light Shades - by TomG - 11-13-2013, 09:09 PM
RE: Light Shades - by f350ca - 11-13-2013, 09:32 PM
RE: Light Shades - by awemawson - 11-14-2013, 05:23 AM
RE: Light Shades - by DaveH - 11-14-2013, 06:50 AM
RE: Light Shades - by stevec - 11-14-2013, 08:10 AM
RE: Light Shades - by DaveH - 11-14-2013, 02:17 PM



Users browsing this thread: 4 Guest(s)