MetalworkingFun Forum › Machining › General Metalworking Discussion v
Light Shades

Thread Modes
Light Shades
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#4
11-13-2013, 12:20 AM
Just back the outside jaws out until they grab the inside of the bowl. You don't need to use the precision part, it's just sheet metal. If you can't grip it tight enough to drill, at least you'll be able to mark the center.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Light Shades - by f350ca - 11-12-2013, 09:58 PM
RE: Light Shades - by TomG - 11-12-2013, 10:22 PM
RE: Light Shades - by f350ca - 11-12-2013, 11:58 PM
RE: Light Shades - by TomG - 11-13-2013, 12:20 AM
RE: Light Shades - by DaveH - 11-13-2013, 04:09 AM
RE: Light Shades - by EdK - 11-13-2013, 06:59 AM
RE: Light Shades - by awemawson - 11-13-2013, 04:09 AM
RE: Light Shades - by f350ca - 11-13-2013, 12:03 PM
RE: Light Shades - by awemawson - 11-13-2013, 12:20 PM
RE: Light Shades - by stevec - 11-13-2013, 07:30 PM
RE: Light Shades - by f350ca - 11-13-2013, 07:29 PM
RE: Light Shades - by TomG - 11-13-2013, 07:37 PM
RE: Light Shades - by stevec - 11-13-2013, 08:04 PM
RE: Light Shades - by f350ca - 11-13-2013, 08:22 PM
RE: Light Shades - by TomG - 11-13-2013, 09:09 PM
RE: Light Shades - by f350ca - 11-13-2013, 09:32 PM
RE: Light Shades - by awemawson - 11-14-2013, 05:23 AM
RE: Light Shades - by DaveH - 11-14-2013, 06:50 AM
RE: Light Shades - by stevec - 11-14-2013, 08:10 AM
RE: Light Shades - by DaveH - 11-14-2013, 02:17 PM



Users browsing this thread: 1 Guest(s)