MetalworkingFun Forum › Machinery › Other Machinery › Band Saws
Band saw blades question

Thread Modes
Band saw blades question
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#16
04-18-2012, 04:05 PM
(04-18-2012, 07:35 AM)Wongster Wrote: Likely the cutting speed. I test and adjust as I go.
Regards,
Wong

I cut everything at the slowest speed, even aluminum. I do increase the down force a bit when I cut aluminum and I cut it dry. But, I don't cut a lot of aluminum so YMMV.

Ed
Reply
Thanks given by:


Messages In This Thread
Band saw blades question - by pjf134 - 04-11-2012, 10:58 PM
RE: Band saw blades question - by aametalmaster - 04-11-2012, 11:32 PM
RE: Band saw blades question - by starlight_tools - 04-12-2012, 12:02 AM
RE: Band saw blades question - by aametalmaster - 04-12-2012, 05:02 PM
RE: Band saw blades question - by Bogstandard - 04-12-2012, 02:25 AM
RE: Band saw blades question - by EdK - 04-12-2012, 05:51 AM
RE: Band saw blades question - by Highpower - 04-12-2012, 07:32 AM
RE: Band saw blades question - by DaveH - 04-12-2012, 07:55 AM
RE: Band saw blades question - by stevec - 04-12-2012, 08:51 AM
RE: Band saw blades question - by ETC57 - 04-12-2012, 01:35 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 01:39 AM
RE: Band saw blades question - by DaveH - 04-18-2012, 06:08 AM
RE: Band saw blades question - by starlight_tools - 04-18-2012, 10:33 AM
RE: Band saw blades question - by EdK - 04-18-2012, 06:26 AM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:35 AM
RE: Band saw blades question - by EdK - 04-18-2012, 04:05 PM
RE: Band saw blades question - by stevec - 04-18-2012, 06:59 PM
RE: Band saw blades question - by Bogstandard - 04-18-2012, 07:05 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:52 PM
RE: Band saw blades question - by Bogstandard - 04-19-2012, 12:30 AM
RE: Band saw blades question - by Wongster - 04-19-2012, 01:33 AM
RE: Band saw blades question - by PixMan - 05-17-2012, 08:26 PM



Users browsing this thread: 6 Guest(s)