11-11-2013, 08:40 AM
Thats easy enough to figure out, or maybe its not. anyway a photo always helps me.
This is part, and the tip size is what controls the flow. this is the valve that opens and closes the oil passage and controls how fast the oil will flow.
![[Image: casted-some-brass-round-sto.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/casted-some-brass-round-sto.jpg)
The tip size controls how large the drops are. the original you see in the photo below has a tip of about and 1/8 inch in diameter with a hole of about 1/16" didn't measure it just grabbed a drill that would slide thru.
![[Image: metering-tube01.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/metering-tube01.jpg)
these little lever handles are what opens and closes the oil passage.
![[Image: lifters-almost-complete.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/lifters-almost-complete.jpg)
This is part, and the tip size is what controls the flow. this is the valve that opens and closes the oil passage and controls how fast the oil will flow.
![[Image: casted-some-brass-round-sto.jpg]](http://s1222.photobucket.com/user/Superdave257/media/casted-some-brass-round-sto.jpg.html)
The tip size controls how large the drops are. the original you see in the photo below has a tip of about and 1/8 inch in diameter with a hole of about 1/16" didn't measure it just grabbed a drill that would slide thru.
![[Image: metering-tube01.jpg]](http://s1222.photobucket.com/user/Superdave257/media/metering-tube01.jpg.html)
these little lever handles are what opens and closes the oil passage.
![[Image: lifters-almost-complete.jpg]](http://s1222.photobucket.com/user/Superdave257/media/lifters-almost-complete.jpg.html)
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!