11-10-2013, 08:34 AM
when I started making this type burner I used 2" sch 40 pipe, thats the smallest diameter that the nozzle will center up in. you can use any size IE 2.5, 3, or 4 inch pipe.
the length is more or less what you want to make it, I make the straight run of pipe that the nozzle is in about 12 to 14 inches long so I have run to cut the line for the blower into the side of it. Thats not saying that you can't run the nozzle lines out the side of the pipe and put the blower straight inline. the only thing that is really locked in stone is the nozzle tip needs to be about .5 to .75 inches back inside the tube.
that photo above was SVSeekers burner.
DA
the length is more or less what you want to make it, I make the straight run of pipe that the nozzle is in about 12 to 14 inches long so I have run to cut the line for the blower into the side of it. Thats not saying that you can't run the nozzle lines out the side of the pipe and put the blower straight inline. the only thing that is really locked in stone is the nozzle tip needs to be about .5 to .75 inches back inside the tube.
that photo above was SVSeekers burner.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!