11-09-2013, 11:17 AM
(11-09-2013, 09:55 AM)EdK Wrote: Nice job on the form tool David.
Ed
it should of been flat on top with no rake, but the bit was one that I had already used for something else and the side I turned up only had a slight negitive rake on it. It actually cut pretty good, I had it on center and would crank the cross slide in about 10 15 thousands and then run the carriage into the part to the depth that I needed, using lots of dark cutting oil.
(11-09-2013, 10:51 AM)DaveH Wrote: Coming a long nicely
DaveH
Dave, I've reached the point of needing the glass tube's, or I may just use some stainless steel tubing I have so I can call them done till I get the glass. They have actually been a lot easier to make then I had first thought they would be.
The one part that I haven't really figured out is the little cover over the filler hole as its spring loaded I may just put in a tube with a drop cap on it and a little chain or something to keep them from getting misplaced.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!