Band saw blades question
#12
(04-18-2012, 01:39 AM)Wongster Wrote: Does bimetal blade cuts everything? Mine seemed blunt after a short while. I cut brass, aluminum & steel with it. So far changed a few blades with each little mileage. I'm using a Proxxon bandsaw.

Regards,
Wong
Brass, Aluminum, Steel, shouldn't be a problem for a bimetal blade, however if it gets too hot it will blunt it. The heat problem normally only occurs whilst cutting steel at too fast a speed. Can the blade speed be lowered ?

Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Band saw blades question - by pjf134 - 04-11-2012, 10:58 PM
RE: Band saw blades question - by aametalmaster - 04-11-2012, 11:32 PM
RE: Band saw blades question - by starlight_tools - 04-12-2012, 12:02 AM
RE: Band saw blades question - by aametalmaster - 04-12-2012, 05:02 PM
RE: Band saw blades question - by Bogstandard - 04-12-2012, 02:25 AM
RE: Band saw blades question - by EdK - 04-12-2012, 05:51 AM
RE: Band saw blades question - by Highpower - 04-12-2012, 07:32 AM
RE: Band saw blades question - by DaveH - 04-12-2012, 07:55 AM
RE: Band saw blades question - by stevec - 04-12-2012, 08:51 AM
RE: Band saw blades question - by ETC57 - 04-12-2012, 01:35 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 01:39 AM
RE: Band saw blades question - by DaveH - 04-18-2012, 06:08 AM
RE: Band saw blades question - by starlight_tools - 04-18-2012, 10:33 AM
RE: Band saw blades question - by EdK - 04-18-2012, 06:26 AM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:35 AM
RE: Band saw blades question - by EdK - 04-18-2012, 04:05 PM
RE: Band saw blades question - by stevec - 04-18-2012, 06:59 PM
RE: Band saw blades question - by Bogstandard - 04-18-2012, 07:05 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:52 PM
RE: Band saw blades question - by Bogstandard - 04-19-2012, 12:30 AM
RE: Band saw blades question - by Wongster - 04-19-2012, 01:33 AM
RE: Band saw blades question - by PixMan - 05-17-2012, 08:26 PM



Users browsing this thread: 1 Guest(s)